收藏本站
Si4464/63/61/60
Selecting shorter conversion times will result in lower ADC resolution and longer times will result in higher ADC
resolution.
?? GPIO_ATT[3:0] - Sets attenuation of gpio input voltage when vgpio measured. Defaults to 0xC if ADC_CFG is 0.
0x0 = ADC range 0 to 0.8V. GPIO_ADC_DIV = 2560
0x4 = ADC range 0 to 1.6V. GPIO_ADC_DIV = 1280
0x8 = ADC range 0 to 2.4V. GPIO_ADC_DIV = 853.33
0x9 = ADC range 0 to 3.6V. GPIO_ADC_DIV = 426.66
0xC = ADC range 0 to 3.2V. GPIO_ADC_DIV = 640
?? Response
?? GPIO_ADC[15:0]
- ADC value of voltage on GPIO
?? BATTERY_ADC[15:0]
- ADC value of battery voltage
?? TEMP_ADC[15:0] - ADC value of temperature sensor voltage
?? RESERVED[7:0] - RESERVED FOR FUTURE USE
?? RESERVED[7:0] - RESERVED FOR FUTURE USE
8.4. Low Battery Detector
The low battery detector (LBD) is enabled and utilized as part of the wake-up-timer (WUT). The LBD function is not
available unless the WUT is enabled, but the host MCU can manually check the battery voltage anytime with the
auxiliary ADC. The LBD function is enabled in the GLOBAL_WUT_CONFIG API property. The battery voltage will
be compared against the threshold each time the WUT expires. The threshold for the LBD function is set in
GLOBAL_LOW_BATT_THRESH. The threshold steps are in increments of 50 mV, ranging from a minimum of
1.5 V up to 3.05 V. The accuracy of the LBD is ±3%. The LBD notification can be configured as an interrupt on the
nIRQ pin or enabled as a direct function on one of the GPIOs.
8.5. Antenna Diversity
To mitigate the problem of frequency-selective fading due to multipath propagation, some transceiver systems use
a scheme known as antenna diversity. In this scheme, two antennas are used. Each time the transceiver enters RX
mode the receive signal strength from each antenna is evaluated. This evaluation process takes place during the
preamble portion of the packet. The antenna with the strongest received signal is then used for the remainder of
that RX packet. The same antenna will also be used for the next corresponding TX packet. This chip fully supports
antenna diversity with an integrated antenna diversity control algorithm. The required signals needed to control an
external SPDT RF switch (such as a PIN diode or GaAs switch) are available on the GPIOx pins. The operation of
these GPIO signals is programmable to allow for different antenna diversity architectures and configurations. The
antdiv[2:0] bits are found in the MODEM_ANT_DIV_CONTROL API property descriptions and enable the antenna
diversity mode. The GPIO pins are capable of sourcing up to 5 mA of current; so, it may be used directly to
forward-bias a PIN diode if desired. The antenna diversity algorithm will automatically toggle back and forth
between the antennas until the packet starts to arrive. The recommended preamble length for optimal antenna
selection is 8 bytes.
Rev 1.2
45
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
SI4465ADY-T1-GE3 MOSFET P-CH 8V 13.7A 8SOIC
SI4466DY-T1-GE3 MOSFET N-CH 20V 9.5A 8-SOIC
SI4470EY-T1-GE3 MOSFET N-CH D-S 60V 8-SOIC
SI4472DY-T1-GE3 MOSFET N-CH D-S 150V 8-SOIC
SI4477DY-T1-GE3 MOSFET P-CH D-S 20V 8-SOIC
SI4483EDY-T1-GE3 MOSFET P-CH D-S 30V 8-SOIC
SI4484EY-T1-GE3 MOSFET N-CH 100V 8-SOIC
SI4488DY-T1-GE3 MOSFET N-CH 150V 8-SOIC
相关代理商/技术参数
SI4463-915-PDK 制造商:Silicon Laboratories Inc 功能描述:KIT DEV WIRELESS SI4463 915MHZ
Si4463-B0B-FM 功能描述:射频收发器 TRX ROM 63 EZRadioPRO RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray
Si4463-B0B-FMR 功能描述:射频收发器 TRX ROM 63 EZRadioPRO RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray
SI4463B1BFM 制造商:Silicon Laboratories Inc 功能描述:
Si4463-B1B-FM 功能描述:射频收发器 TRX RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray
Si4463-B1B-FMR 功能描述:射频收发器 TRX RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray
SI4463BDY 制造商:VISHAY 制造商全称:Vishay Siliconix 功能描述:P-Channel 2.5-V (G-S) MOSFET
SI4463BDY-E3 制造商:VISHAY 制造商全称:Vishay Siliconix 功能描述:P-Channel 2.5-V (G-S) MOSFET